Implement DNS resolution for secondary pool addresses

Test Plan:
[PASS] AIO-SX/DX IPv4 deployment:
       - Bootstrap (single-stack) without issues.
       - Create mgmt vlan network and also secondary pool and
            test other node bootstrap without issues
       - check host swact (for AIO-DX) is operational.
       - check lock/unlock without issues

[PASS] AIO-SX/DX IPv6 deployment: Test same as above

Story: 2011027
Task: 49768

Change-Id: I30ea3a26a5b46a9aad082e89fba83aa476c50079
Signed-off-by: Tara Nath Subedi <Tara.Subedi@windriver.com>

kickstart/files/kickstart.cfg

@@ -2719,31 +2719,16 @@ else  # vlan
     ilog "Configuring vlan: boot_iface=vlan${mgmt_vlan}"
 
     # Check whether to use inet or inet6
-    ipv6_addr=$(dig +short AAAA controller.internal)
-
-    if [[ -z "${ipv6_addr}" ]]
+    # Check for IPv4 format (3 digits followed by a dot, repeated 3 times, and another 3 digits)
+    if [[ $mgmt_ip =~ ^([0-9]{1,3}\.){3}[0-9]{1,3}$ ]];
     then
-        # during an upgrade the controller.internal may not be defined
-        # but the scenario could be IPv6. So try to resolve the controller
-        ipv6_addr=$(dig +short AAAA controller)
-
-        # due to the alias in the /etc/dnsmasq.conf:
-        #     cname=controller,controller.internal
-        # An IPv4 scenario may answer "controller.internal." even for an IPv6 DIG
-        # for this reason, remove the "controller.internal." from the result
-        fqdn_pattern="controller.internal."
-        ipv6_addr=${ipv6_addr/${fqdn_pattern}/}
-    fi
-
-    if [[ -n "${ipv6_addr}" ]]
-    then
-        boot_address_family=inet6
-        ipv6init=yes
-        dhcpv6c=yes
-    else
         boot_address_family=inet
         ipv6init=no
         dhcpv6c=no
+    else
+        boot_address_family=inet6
+        ipv6init=yes
+        dhcpv6c=yes
     fi
 
     # Persist the boot device to the platform configuration. This will get