test/doc/source/manual_tests/system_inventory/system_inventory_installs.rst

System Inventory/Installs

sysinv_inst_01

Test ID

sysinv_inst_01

Test Title

Install with with dynamic IP addressing

Tags

sysinv

Testcase Objective

Install using dynamic IPs

Test Pre-Conditions

N/A

Test Steps

1. Install controller-0, configure it with system configuration file, using DYNAMIC_ALLOCATION IP addressing
2. Bring up controller-1:

• Verify the DHCP discover FM log occurs as expected on host discovery
• Verify that Mgmt. interface FM alarms are raised and cleared as expected
• Check the mgmt IP addresses assigned are in expected range (as specified in /etc/dnsmasq.conf)

3. Bring up the system and check the system functioning as expected

Expected Behavior

1. the active controller is up and all services are running
2. DHCP discover FM log occurs as expected on host discovery
   • mgmt. or infra. interface FM alarms are raised and cleared as expected
   • mgmt. and infra. IP addresses assigned are in expected range
3. Config is up and running

References

N/A

sysinv_inst_02

Test ID

sysinv_inst_02

Test Title

Install with with static addressing and pxeboot

Tags

sysinv

Testcase Objective

Install using static IPs

Test Pre-Conditions

N/A

Test Steps

1. Install controller-0, configure it with system configuration file with STATIC_ALLOCATION IP addressing and pxeboot
2. Bring up controller-1

• Add the host to the inventory

system host-add -n controller-1 -p controller -i <mgmt_ip>

• power on the node and configure it after install finishes

Expected Behavior

1. active controller is up and all servers are running
2. mgmt. interface FM alarms are raised and cleared as expected

• static IPs in mgmt. range are accepted when update the personality of the node

References

N/A

sysinv_inst_03

Test ID

sysinv_inst_03

Test Title

Reinstall a node on a dynamic addressing system

Tags

sysinv

Testcase Objective

Reinstalling a node using dynamic IPs

Test Pre-Conditions

A configuration already working, using dynamic IPs

Test Steps

1. Lock the host to be reinstalled - worker-1 in this case

system host-lock worker-1

2. Delete the host from inventory

system host-delete worker-1

3. Power off the host
4. Power it on (make sure it boots from management NIC)
5. Configure the node personality

system host-update <id> personality=worker hostname=worker-1

6. Allow the node to be installed and proceed to configure it.

Expected Behavior

1. node gets locked
2. node doesn't show up in host-list
3. node with worker personallity assigned
4. node working in the config

References

N/A

sysinv_inst_04

Test ID

sysinv_inst_04

Test Title

Reinstall a node on a static addressing system

Tags

sysinv

Testcase Objective

Reinstalling a node using static IPs

Test Pre-Conditions

A configuration already working, using static IPs

Test Steps

1. Lock the host to be reinstalled - worker-1 in this case

system host-lock worker-1

2. Delete the host from inventory

system host-delete worker-1

3. Power off the host
4. Add the host to the inventory

system host-add -n worker-1 -p worker -i <mgmt_ip>

5. Power it on (make sure it boots from management NIC)
6. Allow the node to be installed and proceed to configure it.

Expected Behavior

1. node gest locked
2. node doesn't show up in host-list
3. node with worker personallity assigned
4. node working in the config

References

N/A